HKP2000sk trigger bite

[Mr. Blue]

Just put a few hundreds rounds through my new H&K P2000sk and noticed a good amount of pinching between the trigger and trigger guard. I really like the pistol, it’s a V2 LEM 9mm. I called HK but they were of no help. Is there an extended trigger guard, different trigger shoe? Maybe a blade that isn’t so curved?
In the picture, it shows my finger at the wall, when it breaks, my cuticle either gets pinched or simply stabbed from the sharp front edge of the trigger. Again, this isn’t the end of the world, but it distracts enough for me to try and change my grip as accuracy suffers.

[jimmythebrain]

feel the edge of the molded trigger. Is there a mold line?
Mine had a mold line that created a sharp point, my finger would run over this and feel like it was getting pinched.
I took out the trigger and did a spring swap. While the trigger was out I used a file to remove the sharp molding edge-JS

[Mr. Blue]

feel the edge of the molded trigger. Is there a mold line?
Mine had a mold line that created a sharp point, my finger would run over this and feel like it was getting pinched.
I took out the trigger and did a spring swap. While the trigger was out I used a file to remove the sharp molding edge-JS

[jimmythebrain]

Yes, the callous formation of the finger modification may reduce your pain.
I had the same problem with my Walther P99.
I found having a higher grip and concentrating on trigger pull helped me a lot. As I fatigued and my shooting discipline degraded the pinching became worse.