-
-
I installed the sight new after purchase with zero rounds -
Lock-tite.ΜΟΛΩΝ ΛΑΒΕPaul
Confirmed Domestic Terrorist & NRA Member
Bobby SandsComment
-
I used blue lucite to keep my XD front sight from falling out.
.Be sure to ask your doctor if depression, rectal bleeding, and suicide are right for you.
In the United States a person's expertise on a subject is inversely proportional to their knowledge of the subject: The less they know about something, the more they become an expert on it.
I am being held hostage in a giant insane asylum called Earth.Comment
-
Thanks I needed to use the sight vise as the tolerance was tight installing .. would excessive firings create enough heat on the slide to soften the loctite?
270: blue loctite
271: red loctiteComment
-
A gunsmith would probably install a shim under the sight, or stimple the slide's dovetail bottom surface with a sharp punch in order to displace some metal. Loctite (blue) might work; its pretty unlikely the top of your slide will reach 270 degrees to release it."You keep using that word. I do not think it means what you think it means."
"What we get away with isn't usually the same as what's good for us"
"An extended slide stop is the second most useless part you can put on a 1911"
"While Ruger DA revolvers may be built like a tank, they have the aesthetics of one also,
although I suppose there are a few tanks which I owe an apology to for that remark"Comment
-
You could also peen the dovetail base of the sight out near the edge. I would try a shim under it first, maybe cut from a piece of aluminum can.Comment
-
Thanks the shim sounds like a great idea for starters and it would also be And easy mod to use the punch on the other side of the slide to display some material and close up the tolerance gap at the dovetail as always Calgunners Helping Calgunners!Comment
-
Comment
-
Thx!Comment
Tweet
There are currently 3718 users online. 25 members and 3693 guests.
Most users ever online was 65,177 at 8:20 PM on 09-21-2024.
Comment