Need a 9mm P220 ejector

[bayonet]

I'm looking for a replacement part for this pinched nosed classic 9mm pistol. Does anyone know where I can buy one? Thanks

[Barang]

https://www.gunpartscorp.com/products/872370A

try numrich.

[aca72]

You mean extractor?

https://www.ebay.com/itm/273520739599

...Here are extractors for old model Sig Sauer Pistols chambered in 9mm or .38 Super, with old type internal extractors that fit into rolled steel slide assemblies. That includes most Sig Sauer Models P220, P225, P226, and P228 pistols manufactured from 1975 until about 1998. Construction is pre-hardened, 4140 milled steel. Finish is gloss black oxide. Replacement pricing is upwards of $50 apiece on these, if a person can even find one. They have been discontinued by the factory...

[golfrj]

buy two!

[P5Ret]

OP do you need an extractor or ejector? The ejector tab is part of the slide stop lever, you need to replace that part if it's the ejector.

[bayonet]

Thanks for the responses, but I'm looking for the ejector/slide lock.

[damon1272]

[Barang]

Thanks for the responses, but I'm looking for the ejector/slide lock.

oh boy! my eyes was reading extractor when you're asking ejector.

[P5Ret]

OP according to my 20+ year old Sig armorers manual most parts are supposed to be interchangeable.

I'd give one for a .45 a try it's under $20, or call Gray guns in OR, they may be able to steer you in the right direction.