Singleshot exemption? or No?

[ZX9ALLDAY]

Will this work under single shot exemption? Pocket cannon?! Heizer PAR1, single shot .223 Pocket AR

https://www.classicfirearms.com/heizer-defense-par1blk-def-pocket-ar/

[plumbum]

Barrel and OAL too short.

[shootsocal_dave]

ouch, that would hurt! and I agree, its too small to qualify.

ARTICLE 6. Exceptions to Rules Governing Unsafe Handguns [32100 - 32110] ( Article 6 added by Stats. 2010, Ch. 711, Sec. 6. )

PC 32100.

(b) Article 4 (commencing with Section 31900) and Article 5 (commencing with Section 32000) shall not apply to a single-shot pistol with a break top or bolt action and a when the handle, frame or receiver, and barrel are assembled. However, Article 4 (commencing with Section 31900) and Article 5 (commencing with Section 32000) shall apply to a semiautomatic pistol that has been temporarily or permanently altered so that it will not fire in a semiautomatic mode.

[ZX9ALLDAY]

Damn that would have been fun.... kind of....Thanks

[elSquid]

What about the AK version with a sub caliber barrel insert?



But seriously, why doesn't Heizer get these things rostered?

-- Michael

[elSquid]

Or another idea...

Heizer sells replacement barrels.

https://heizerdefense.com/category/products/other/barrels-2/

Buy a replacement barrel for the gun you want, get it threaded and an extension permanently attached so that it makes length, swap the new barrel on and presto!

After DROS and pickup, swap the original barrel back on, sell the modified barrel to another calgunner that wants one of these things.

As well, a smart dealer could simply have a bunch of modifed barrels in stock for customers to use...

-- Michael

[SkyHawk]

What about the AK version with a sub caliber barrel insert?



But seriously, why doesn't Heizer get these things rostered?

-- Michael

A rifled subcaliber barrel insert around 9.5" would work. The 7.62 round has a ~.40" shoulder That leaves a lot of room for a 22 rimfire insert.. I would try and make a 22 short with a slightly offset chamber so the centerfire firing pin could set off the rimfire round. That is how these 45LC cartridge conversions work

Or another idea...

Heizer sells replacement barrels.

https://heizerdefense.com/category/products/other/barrels-2/

Buy a replacement barrel for the gun you want, get it threaded and an extension permanently attached so that it makes length, swap the new barrel on and presto!

After DROS and pickup, swap the original barrel back on, sell the modified barrel to another calgunner that wants one of these things.

As well, a smart dealer could simply have a bunch of modifed barrels in stock for customers to use...

-- Michael

Better yet, make the sub-cal insert for the 7.62. Then after DROS you can remove the insert and you will have 7.62, and you can swap on any other barrel you want (except the .410). Then you would have 7.62 and .223.

Then sell the subcal insert, or if you are a dealer keep it for the next guy. Just like the old SSE days.

Also note you could never have the gun and .410 barrel in your possession at the same time in CA.

[Yodaman]

No and no