Kydex Remolding Possible?

[SweetPotato]

You already have some good advise above, particularly about not having enough material to accommodate an add-on.

If I were in your situation, I would think: There probably is enough material to make "something" out of it. What the "something" will be is likely to be an abomination after I'm done with it.

Yeah, I saw and understand them earlier. I am getting additional knowledge of how kydex is handled which is still good. But...I am just not sure what to do with this holster once I order a new one.

When you heat Kydex it tends to straighten it self out unless there are molds or clamps shaping it.

What model holster are you trying to reshape? Is it a model originally molded for a non-TLR equipped gun? Are there tension screws, if so where are the tension screws located?

G43 without TLR. There are no tension screws. I take a look closer and found that the button that is used to pin the kydex is right on the spot where the TLR would be so it is not possible to reshape it even if I want to. Thanks for reminding me to check JTROKS.