Unconfigured Ad Widget

Collapse

Problem with Glock Lightning Strike Guide Rod

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • pacrimguru
    Veteran Member
    • Sep 2008
    • 3595

    Problem with Glock Lightning Strike Guide Rod

    hey guys, i have a problem with a Glock Lightning Strike Guide Rod (steel, w/ catptured spring) that i just installed. when racking the slide back, the guide rod binds and the spring scrapes the rod to the point that the slide gets very difficult to pull all the way back.

    when checking it out in detail, it looks like the smooth steel base of the guide rod slips a bit where it meets the barrel and kinks it at a very slight angle when pulling on the slide. this is enough to make the entire slide bind when racking it back. i even clp'd the rod but the spring does not allow for a smooth pull back.

    my questions are, has anyone else experienced this? i've never bought anything from Lightning Strike before. is their quality subpar? am i doing something wrong here? it seems unlikely since this is a drop in part.

    here's the part on brownells:
    Glock Lightning Strike Guide Rod
  • #2
    inkedshooter
    Senior Member
    • Feb 2008
    • 574

    What model Glock do you have? By chance did you see if the part number for the guide rod and spring you got is correct? The fit of those guide rods is usualy pretty good. What spring rate did you go with?

    Comment

    • #3
      pacrimguru
      Veteran Member
      • Sep 2008
      • 3595

      thanks for the response. i have a 17 and ordered this one from brownells: "642-000-010, 17/22 Captured". it doesn't say what rate the spring is, but i can tell its a lot stiffer than the original one. is there any way to get the stock spring off the plastic rod? i'm thinking of swapping the springs to see what happens.

      Comment

      • #4
        saki302
        Calguns Addict
        • Oct 2005
        • 7193

        If you take a long allen key (or other rod), and hammer it through the hole in the back of the guide rod, the cap pops off and the stock spring comes out.

        Maybe your guide rod is thicker to accomodate the standard recoil springs and the flat type springs don't have enough clearance to work right?

        -Dave

        Comment

        • #5
          inkedshooter
          Senior Member
          • Feb 2008
          • 574

          The guide rod should be a drop in fit. You can take off the factory one but it's a pain. You may want to swap out the one on the steel guide rod with something lighter like a 15lb, 17lb is factory. Try taking off the spring thats on the steel guide rod and see if there are any signs of the spring binding on the guide rod, scrape marks.
          Last edited by inkedshooter; 01-17-2009, 9:44 PM.

          Comment

          • #6
            pacrimguru
            Veteran Member
            • Sep 2008
            • 3595

            thanks dave, i'll have the check it out.

            good call inked, i'll try that. thanks!

            Comment

            • #7
              Oldnoob
              Veteran Member
              • Apr 2008
              • 2829

              I remember someone on GlockTalk mention the same problem. He made the call back to Lone Wolf(I think), and it turn up there were a bad batch of springs which were few mm too long.
              Taiwan born, Chinese descent, red white and freaking blue America citizen.

              Gun Control - A theory espoused by some monumentally stupid people; who claim to believe, against all logic and common sense, that a violent predator who ignores the laws prohibiting them from robbing, raping, kidnapping, torturing and killing their fellow human beings will obey a law telling them that they cannot own a gun.

              Comment

              Working...
              UA-8071174-1