who does annodizing?

[13Delta]

i got a 601 lower in the white ,and it needs some type III annodizing, i already emailed US Annodizing and they have yet to respond, so i'm hoping someone local could do it(LA area). so i can finish my retro build.

[pklin1297]

I have sent aluminum gun parts to powder coaters, and general anodizing shops who also do paintball guns, motorcyle parts, etc. Turned out just fine.

If Anaheim is not too far, www.techplate.com will do anodizing. Email Marshall for pricing quote or any questions you may have.

[dw1784]

Burbank, http://www.klanodizing.com/
Downey, http://www.universalmold.com/
LA, Alhambra Ave, near Cal State LA, http://www.anodizingindustries.com/
LA, Whiteside Ave, also near Cal State LA, http://www.valmont.com/asp/coatings/finishes/

[NeoWeird]

Anyone use any of them and know, roughly, what they charge for an upper and lower to be anodized assuming it needs no prior prep work?

[ar15barrels]

Anyone use any of them and know, roughly, what they charge for an upper and lower to be anodized assuming it needs no prior prep work?

Anodizing usually runs about $75 minimum lot charge for type II.
That will usually get you about 10lbs of aluminum parts done.
If you want type III, it's going to be more expensive, probably $120 to $150.

[13Delta]

i finally sent it to US Annodizing for type III annodizing in early colt gray $75. shipping to/back and insurance $40. I'll post pics when i get it back.