Tweet
Anybody else getting tired of the amount of muscle it takes to work on factory MFG uppers and the such?
Seems the small companies are OK- but the big guys, Stag, RRA, LMT, S&W, Bushmaster and the worst- Armalite and DPMS... jeez- you can't take the uper apart to swap forends. gas blocks, install muzzle brakes, etc...
You can't sell me on the point that putting everyting together with red locktite and 1000 ft/lb of torque makes a better gun.
taper pins should not require a 200 ton press to take out. A barrel nut wrench should not require 5 foot cheater bar.
Seems the small companies are OK- but the big guys, Stag, RRA, LMT, S&W, Bushmaster and the worst- Armalite and DPMS... jeez- you can't take the uper apart to swap forends. gas blocks, install muzzle brakes, etc...
You can't sell me on the point that putting everyting together with red locktite and 1000 ft/lb of torque makes a better gun.
taper pins should not require a 200 ton press to take out. A barrel nut wrench should not require 5 foot cheater bar.
