HK USP with match trigger ?

[newbie1234]

The SA trigger pull on my all stock HK USP Elite is 4.5#. If I install the match trigger then what is my SA trigger pull will be ?

[Romeo_alpha01]

It would be the same. Experts and elites pretty much have the same trigger as the match. Same goes for tacticals

[jsigone]

Your elite should have a match trigger already, I’m surprised yours is at 4.5#, thought they were 3.5-4.0# with match and add a pound for standard trigger. I need to put a pull gauge in my expert but I’m sure is 4 or under and still pretty new.

[newbie1234]

Your elite should have a match trigger already, I’m surprised yours is at 4.5#, thought they were 3.5-4.0# with match and add a pound for standard trigger. I need to put a pull gauge in my expert but I’m sure is 4 or under and still pretty new.

I just measure it again with my only Wheeler (mechanical) gauge, the gun position is in firing position (up position), and mount to a vise. For about 10 tries the reading is around 4.5# consistency. This gun has been shoot 1.5K rds. I remember I had the same reading from day one.

Note that , with the same gauge I can read 2.5# and 3.5# on difference pistols so I don't think my gauge is out of calibrated, and I clean the HK Elite after every range trip every 100-200 rds or so.

[Romeo_alpha01]

I just measure it again with my only Wheeler (mechanical) gauge, the gun position is in firing position (up position), and mount to a vise. For about 10 tries the reading is around 4.5# consistency. This gun has been shoot 1.5K rds. I remember I had the same reading from day one.

Note that , with the same gauge I can read 2.5# and 3.5# on difference pistols so I don't think my gauge is out of calibrated, and I clean the HK Elite after every range trip every 100-200 rds or so.