Hammer Strut Support (Ruger)

[SDDAVE56]

I just installed this on my Ruger Standard Model. OMG reassembly is a breeze now. Why did I not do this years ago! I watched the video, and ordered one. Installation took less then five minutes. Reassemble, less then thirty seconds.

https://www.hammerstrutsupport.com

[Abenaki]

Thanks for posting this.

Take care
Abenaki

[stormvet]

That?s pretty nifty, but I?ll be honest in the close to 30 years I?ve owned my MKII. I can count the number of times I?ve disassembled the gun for cleaning on one hand. The vast majority of times I just give it a whores bath type cleaning, after all these years and so so many rounds fired still runs like a top.

[Calif Hunter]

Originally Posted by stormvet

That?s pretty nifty, but I?ll be honest in the close to 30 years I?ve owned my MKII. I can count the number of times I?ve disassembled the gun for cleaning on one hand. The vast majority of times I just give it a whores bath type cleaning, after all these years and so so many rounds fired still runs like a top.

I am as neglectful as you are - a good spray with Hornady One Sh0ot Cleaner/Dry Lube in the action along with a bore snake has been sufficient for decades on my MKII target, It still functions 100% and shoots better than I can take advantage of.

[SDDAVE56]

I like to take apart, and clean mine, if I know its going to be a while when I shoot it again. This little part just makes it so much easier to reassemble though. Food for thought.

[Oneaudiopro]

Originally Posted by Ishootforblood

In many cases, firearms suffer the most wear & tear from frequent disassembling and excessive or improper cleaning.

^^^^^^THIS^^^^^ Absolutely no reason to do a complete disassembly on a Ruger MKI/II