|
Rimfire Firearms .22, .17 and other Rimfire Handguns and Rifles |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Ruger 10/22 Takedown question
I have a 10/22 takedown with the Magpul backpacker stock.
I have the factory rail installed with a red dot. With the rail in place, if I remove the red dot, I still can not use the factory sights. I put on a set of tech sights (TSR200RL), but could not zero them for windage. The front sight was just too far to the left, making point of impact right of the point of aim. I had the red dot zeroed, so I could see the issue with the front sight pretty easily. Are those sights not a good fit for the takedown? I really like the ghost rings on my PCC. Is there version of those for the 10/22 Takedown? Looking for some advice, as I want iron sights I can use with the red dot. TIA
__________________
Necessity is the plea for every infringement of human freedom. It is the argument of tyrants; it is the creed of slaves. - William Pitt |
#2
|
|||
|
|||
__________________
Necessity is the plea for every infringement of human freedom. It is the argument of tyrants; it is the creed of slaves. - William Pitt |
#3
|
|||
|
|||
I installed this mount and use the factory sights. Works real well and keeps the red dot zeroed to the barrel.
https://www.magpul.com/products/x-22...er-optic-mount |
#4
|
|||
|
|||
Quote:
__________________
Necessity is the plea for every infringement of human freedom. It is the argument of tyrants; it is the creed of slaves. - William Pitt |
#5
|
||||
|
||||
The EGW rail for the take-down is made so you can use the irons.
http://www.egwguns.com/scope-mounts-...-ambidextrous/
__________________
Bob B. (\__/) (='.'=) (")_(") |
#6
|
|||
|
|||
Yes it does. Use the non-raised cheek piece from magpie and Irons are no problem. I run the raised cheek piece and it is right on for the red dot.
|
#9
|
|||
|
|||
There's a "see through" riser Pic rail I've used on 10/22s (got one on a TD I put together with a backpacker stock). It looks like a square tube, rail on top, holes that line up with your receiver on the base. You can just see the factory sights through that as the base is thinner than a typical rail, and mount your red dot up top. Around $10 on ebay...
|
Thread Tools | |
Display Modes | |
|
|