Gunsmith

[ArdavanSh]

Hi, I am looking for a gunsmith specialized in sig handguns. I have a p226 and trying to cut the slide so I could install a RMR sight, would appreciate any recommendation. Thanks

[9Cal_OC]

Cut the barrel?

In any case, try Randall. I’ll look for his information shortly.

https://www.calguns.net/calgunforum/member.php?u=6073

[ArdavanSh]

Originally Posted by 9Cal_OC

Cut the barrel?

In any case, try Randall. I’ll look for his information shortly.

https://www.calguns.net/calgunforum/member.php?u=6073

my bad, i meant the slide
thanks

[Garv]

Where are you located?

[ArdavanSh]

Originally Posted by Garv

Where are you located?

Dtla

[Garv]

Then I agree you should contact Randall first. . Van Nuys.

Good luck.

Edit: My bad. I did not see the subforum name.

[ArdavanSh]

Originally Posted by Garv

Then I agree you should contact Randall first. . Van Nuys.

Good luck.

Edit: My bad. I did not see the subforum name.

thanks, appreciate it

[saki302]

Best advice re slide cuts for sights- find a shop that does it professionally and send them your slide.

Most of this is a CNC operation, and shops set up for that specific cut can do it quickly and relatively cheaply.

[ArdavanSh]

Originally Posted by saki302

Best advice re slide cuts for sights- find a shop that does it professionally and send them your slide.

Most of this is a CNC operation, and shops set up for that specific cut can do it quickly and relatively cheaply.

Thank you, do you know of any shop that do that?

-----------------
I contacted Randall and he does not do rmr slide cuts :/

[saki302]

I would check Google or the sig forums. I found a shop that cut my glock 21 for $75 and did a good job, but they don't do sigs.

[Garv]

OP:

OK, I suggest you create a new thread in the Gunsmithing section to get more people looking at it.

The forum is lightly viewed.

[ArdavanSh]

I created a new thread in Gunsmithing section, thanks everyone for the help