|
Optics, Mounts, Rails and Sights If it aims your firearm, post about it here. |
|
Thread Tools | Display Modes |
#2
|
||||
|
||||
If it's installed with the existing dovetail, there isn't much the smith can do about that gap. That could just be the tolerance on these sights.
__________________
NRA Benefactor Life Member NRA Certified Pistol, Rifle & Refuse To Be A Victim Instructor American Marksman Training Group Visit our American Marksman Facebook Page Diamond Bar CCW Facebook Page NRA Memberships at Discounted fee |
#3
|
||||
|
||||
As long as the pistol shoots to an acceptable point of aim vs. point of impact, this isn't an issue. Consider this also; if the sight were configured so that the rear was flush with the top of the slide when installed, it would likely damage the finish under it when installed.
__________________
I'm retired. That's right, retired. I don't want to hear about the cop who stopped you today or how you didn't think you should get a ticket. That just makes me grumpy! |
Thread Tools | |
Display Modes | |
|
|