Quote:
Originally Posted by sofbak
Is your sizing die contacting the shell holder and the end of the stroke? It looks like the die is stopping "short" and leaving a short length of the case un-sized. The case taper should continue up to the shoulder and it appears that a little of it is left straight walled instead if tapered.
jmho...
|
Quote:
Originally Posted by baih777
Adjust your die tighter 1/16th of a turn at a time till your cases cycle.
|
Quote:
Originally Posted by DGoodale
I'll try, but if I go much more it won't cam over, which isn't the worst but just jars to a stop at the top of the stroke.
Oh the case fits and looks good in a go/no go gauge.
|
Well, my apologies. This is one time I'm glad to be wrong. I guess I should go back to the basics. I tightened the die down and test fed in the gun before and after and it solved the problem. The brass would barely go into battery before and after it went right in. Thanks! Dave