I was able to figure it out without instructions. Pretty simple if you take your time. I am quite pleased by the end result and cost effectiveness of this product.
Like Sigbird noted, the top hole is a little too small to accept the upper pin so you will have to drill it. This added about 2 mins to the process for me.
Quote:
Originally Posted by Sigbird
Best product bar none for pinning your Magpul stock @ $11 to your door. Keeps the factory look and your stock won't move a MM. FYI, You will need to clean up the top hole with the same diameter drill bit for the upper pin to fit. Otherwise 5 min to install.
|