View Single Post
  #8  
Old 11-22-2019, 12:37 PM
creampuff creampuff is offline
Village idiot
CGN Contributor
 
Join Date: Jan 2006
Posts: 3,187
iTrader: 0 / 0%
Default

Quote:
Originally Posted by 1911Luvr View Post
If the extractor alignment is the problem and you have verified this, you can tune the bottom of the extractorís front edge with a file to put an angle on it that will allow the extractor to ride over that tiny point of contact. Itís not the ideal solution as it places a small amount of upward tension on the extractor, but if the interference is only 1 or 2 thousandths (which it likely is), this should fix it for you.


Sent from my iPhone using Tapatalk
yes, but I was looking for an excuse to buy a $150 barrel for a $270 gun
Reply With Quote