View Single Post
  #20  
Old 07-02-2011, 2:28 PM
triggs75's Avatar
triggs75 triggs75 is offline
Senior Member
 
Join Date: Sep 2010
Location: NorCal
Posts: 1,726
iTrader: 24 / 100%
Default

Here is an update of my build so far. Taking it slow

The DPMS mag catch is not holding in the magazine. I ordered the Armalite AR10 mag catch since I have heard this will fix the issue. It has a longer threaded stud for better thread engagement.The catch portion itself is slightly taller allowing a better catch on the magazine.

The Extended Bolt Release v2/308 (EBRv2/308) was horrible so I took it off. I guess its not the EBR's fault. The CMMG lower trigger hole is small so to me there was not enough room in there for it. Also the EBR was hitting the CMMG lower part where it comes out on the lower not allowing a smooth function.

Oh and the CMMG lower finish was chaulky so i Sprayed it with a little Desert Mirage Brown Duracoat Will do this prbably with the upper as well. Not sure yet though.

Build so far consist of:
CMMG .308 Lower
DPMS Lower Receiver Parts Kit Less Trigger Group (.308)
Mil-Spec Receiver Extension 6 Position
Command Arms ACC Grip
Magpul PMAG LR20 10/20

Parts needed:
16 Bushmaster Moe style upper
Chrome BCG
Geissele Super Semi-Automatic Trigger
Magpul CTR Carbine Mil Spec - In The Mail
castle nut / receiver end plate - In The Mail
Car-10 Bufffer Assembly (heavybuffers.com)
Battle Arms Development - Ambidextrous Safety Selector (BAD-@$$)
VLTOR BCMGUNFIGHTER Charging Handle (7.62mm/.308) w/ Mod 4




Chad
Reply With Quote