View Single Post
  #24  
Old 10-27-2017, 1:53 PM
PoorMan's Avatar
PoorMan PoorMan is offline
Senior Member
 
Join Date: Sep 2011
Location: Kalifornistan
Posts: 780
iTrader: 16 / 100%
Default

I was able to figure it out without instructions. Pretty simple if you take your time. I am quite pleased by the end result and cost effectiveness of this product.

Like Sigbird noted, the top hole is a little too small to accept the upper pin so you will have to drill it. This added about 2 mins to the process for me.


Quote:
Originally Posted by Sigbird View Post
Best product bar none for pinning your Magpul stock @ $11 to your door. Keeps the factory look and your stock won't move a MM. FYI, You will need to clean up the top hole with the same diameter drill bit for the upper pin to fit. Otherwise 5 min to install.
Reply With Quote