Calguns.net

Calguns.net (https://www.calguns.net/calgunforum/index.php)
-   AUDIOPHIL2 (https://www.calguns.net/calgunforum/forumdisplay.php?f=376)
-   -   FS2000 Middle man service (https://www.calguns.net/calgunforum/showthread.php?t=1743571)

LovestheFaMAS 09-07-2021 6:45 PM

FS2000 Middle man service
 
Hi Phil,

Firstly, I wish you a speedy recovery. ****'s no joke...

With that being said, I found this FS2000 on gunbroker.com:

https://www.gunbroker.com/item/909852309

I live in California, and I was wondering if it is possible to act as a middle man and make this thing CA compliant. The overall length of the gun is JUUUUUST shy of 30", so I would imagine it needs an extended muzzle brake and to have the thumbhole stock covered.

Thank you very much, again, I hope you get better soon.

- Mike

HibikiR 09-08-2021 2:55 AM

Dunno if anything's changed in the last few years, but Phil did one for me a while back so if he's still doing that then I'd trust him with the job.

For the 30" requirement, I went with one of these: https://mfiap.com/i-7605745-mfi-m4-b...insurance.html

For the stock cover: https://fingrips.com/

LovestheFaMAS 09-08-2021 1:30 PM

Quote:

Originally Posted by HibikiR (Post 26139328)
Dunno if anything's changed in the last few years, but Phil did one for me a while back so if he's still doing that then I'd trust him with the job.

For the 30" requirement, I went with one of these: https://mfiap.com/i-7605745-mfi-m4-b...insurance.html

For the stock cover: https://fingrips.com/

That's good to know he's done this before. The bid ends in 3 days so I'm hoping Phil is well enough to check this out prior to the end of the bid.

When Phil did this for you, did he require you to order the parts and send them to him, or was he able to order the parts and put it together?

Also, would you happen to have a picture of your FS2000?

Thanks Hibiki!

HibikiR 09-08-2021 2:24 PM

Don't have a pic of it, but it does look like the example pic at MFIap.

Yes, I did have to get the two compliance parts and send them to Phil for him and his team to install.


All times are GMT -8. The time now is 4:34 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2021, vBulletin Solutions Inc.