View Full Version : Did my own trigger job on my AR and...
Rimack
03-21-2014, 9:17 PM
It worked great!
I took a polishing stone to it and that made a huge improvement. Clean break and no more gritty feel!
If you have a stock trigger and haven't done it yet do some research and go slow, but you will definatly feel the difference.
Can't wait to take it out tomorrow!
SocomM4
03-22-2014, 3:52 AM
Little grease will make it even better.
ky2970
03-22-2014, 4:53 AM
Let us know how it goes! Make sure you use some ammo with hard primers to make sure it's still fully functional.
davidb
03-22-2014, 5:06 AM
nice! i might give it a try on a ptac trigger
mark501w
03-22-2014, 5:57 AM
They're supposed to have a hardened surface on ar triggers ,knock that off with a stone & you'll have trouble later. Jp spring kit, Brownell's 20$ 6-3.5lbs add GTX grease.
Rimack
03-22-2014, 7:41 AM
They're supposed to have a hardened surface on ar triggers ,knock that off with a stone & you'll have trouble later. Jp spring kit, Brownell's 20$ 6-3.5lbs add GTX grease.
I tried not to really take off any metal, just smooth it slightly.
I plan on installing a Timney later, so hopefully it will last long enough.
vBulletin® v3.8.11, Copyright ©2000-2024, vBulletin Solutions Inc.