PDA

View Full Version : Savage Model 99 Problem


roushstage2
09-06-2012, 12:17 PM
Hey guys. I have a Model 99 that a local shop cleaned for me when I first inherited it (last year) and ever since then, the automatic cut-off will stick out just a hair too far and jam against the receiver to where the bolt won't close. Normally, the cut-off would not pop out far enough to touch the receiver and subsequently get caught, so the bolt would just push it back in. When it gets caught, if I just tap it with my finger, it will become unstuck and work as normal until it catches again.

Part 19 here:
http://www.urban-armory.com/diagrams/savage_99.gif

Any ideas what might be causing this? All there is to it is the cut-off and the cut-off spring. Perhaps the spring was put it backwards/upside-down, if that's possible?

kcstott
09-06-2012, 2:38 PM
I'd pull it out and inspect for burrs or damage. See if it will fully seat with out the spring. The spring might be kinked causing a problem.

roushstage2
09-06-2012, 5:02 PM
I'll have to find a guide on how to take it apart first. Once I do, I'll break it down and check.