View Full Version : dust cover spring...damn thing
hawkinpup
01-30-2011, 4:01 PM
is there some kinda trick to installing the dust cover and spring?
joelogic
01-30-2011, 4:05 PM
I used needle nose pliers to twist the spring and then pushed the hinge pin with the other hand.
killshot44
01-30-2011, 4:06 PM
is there some kinda trick to installing the dust cover and spring?
Do it before the barrel is on.....
hawkinpup
01-30-2011, 4:08 PM
really needle nose pliers, I tried that, guess I need stronger glasses, and some more patience.
hawkinpup
01-30-2011, 4:31 PM
got it.
thanks
joebrock
01-30-2011, 5:07 PM
-Place the cover in the open position between the two holes
-insert the hinge pin through the rear hole until it is visable about half way into the opening where the spring goes.
- slide the spring over the hinge pin with the little side up and to the rear
- using your finger, twist the long side of the spring clockwise 1 time, resting it on the cover
- push the hinge pin all the way in
- install the c-clip
Dhena81
01-30-2011, 5:17 PM
Skip to 1:25 and you should be GTG :D
0J57W4xz6Uw
vBulletin® v3.8.11, Copyright ©2000-2024, vBulletin Solutions Inc.