|
Rimfire Firearms .22, .17 and other Rimfire Handguns and Rifles |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Lead nose 22LR in my AR safe queen?
Ive been using the hell out of my CMMG 22LR conversion bolt carrier lately. Finally i can enjoy my AR without thinking about dollar signed with each trigger pull.
I had a friend trade me some old bricks of Remington Thunderbolt, which is lead round nose with some sort of coating or lacquer. Im used to shooting copper plated Mini Mags or equivalent. Is there any issue with shooting bare lead out of a chromed lined AR barrel? Any different cleaning procedure needed?
__________________
"...the lust for power can be just as completely satisfied by suggesting people into loving their servitude as by flogging and kicking them into obedience." -Aldous Huxley Last edited by Caligula36; 04-02-2021 at 10:09 PM.. |
#3
|
||||
|
||||
I’ve always had good luck with the Remington Thunderbolts, granted I don’t shoot them out of a AR conversation. But 10/22, Marlin 795, Buckmark, Mark II, SR22, S&W and Ruger wheelguns all shoot and function great with them. Yes they do run a little dirtier then copper plated, but nothing extreme or to worry about. I’ve shot tens of thousands of them over the years.
__________________
Im a warmonger baby, I got blood in my eyes and I'm looking at you. |
#4
|
||||
|
||||
I would worry about lead fouling up the gas tube. For sure you may want to shoot some 5.56 after each lead 22LR session to blow the junk out of the gas tube. I don't know for sure if lead ammo will cause more fouling in the gas tube over plated ammo, but it might. I try and stick to the plated stuff in my bolt conversion upper, usually Winchester M22.
Last edited by SkyHawk; 04-03-2021 at 12:06 PM.. |
#5
|
||||
|
||||
I shoot any 22lr that will cycle the conversion kit. Plated or sans plating. No noticeable difference to me.
Finish up with a 556 round and then clean it as usual.
__________________
"Find out just what the people will submit to and you have found out the exact amount of injustice and wrong which will be imposed upon them and these will continue until they are resisted with either words or blows, or with both. The limits of tyrants are prescribed by the endurance of those whom they oppress." -- Frederick Douglass -- “I didn’t know I was a slave until I found out I couldn’t do the things I wanted.” – Frederick Douglass -- |
#7
|
|||
|
|||
Kind of funny, I bought the CMMG 22LR kit so I wouldn't need to drag the 416-22 along with my AR, but the accuracy with the CMMG kit turned out to be pretty crap compared to the 416-22 past 25 yards on my 17" BA Hanson barrel. If not for the convenience factor, I'd sell it and just get a proper upper, but it's going in the closet whenever I have space for the 416.
|
Thread Tools | |
Display Modes | |
|
|