#1
|
||||
|
||||
question about your 10/20 pmags
I bought two of your 10/20 pmags about 4 monthsago. they have worked well. I went to go service them(wanted to take them apart and wipe'm down) and i cant get the floor plate off even with the button pushed in. do you glue or epoxy the floor plate back on?
|
#4
|
||||
|
||||
Our 10/20, 10/30 mags all have a permanently attached floorplate. We are a CA dealer with a high-cap magazine permit and it is in our best interest to make sure the DOJ does not get any excuse to yank our permit. Mags that only require someone to break off a stick attached to the follower are not "permanent enough", in my opinion, for us to sell as 10 rounders. I feel that it is perfectly legal if an individual wants to make that modification themselves, but since we have much greater liability I don't want to take the chance.
|
#7
|
|||
|
|||
Quote:
You could also use the traditional soap and hot water. The dishwasher can work wonders. Just make sure you dry them REALLY well. Last edited by Casual Observer; 02-19-2009 at 5:28 PM.. |
#9
|
|||
|
|||
We have several hundred more on order. Magpul just can't produce them fast enough I guess along with everything else they make. There's no ETA really. If we're lucky, we'll get a call or email a few days before they show up. |
#11
|
||||
|
||||
Sure, just send us an email with your order number or other info so we can look it up.
|
Thread Tools | |
Display Modes | |
|
|