|
|
|
|
|
|
|
|
|
 |
|
|||||||
| Gunsmithing & How To Pro, Amateur & WECSOG and Tutorials, Guides & OLL Build Instructions |
 |
|
|
Thread Tools | Display Modes |
|
#1
04-16-2017, 12:42 PM
|
||||
|
||||
Broken Teeth...
I have gotten a few really crap barrel nuts from BCM that are going back..teeth are breaking at less than 45 pounds...also 2 from Windham..maybe some bad lots out there..just FYI..and yes..I do know how to install them before anyone asks..and I use Aeroshell..
__________________
07 FFL Farwest Photography 408 217 9148 https://farwestffl.com/ https://www.facebook.com/FarwestFFL/ https://www.instagram.com/farwest_ffl/ https://www.yelp.com/biz/farwest-pho...hy-santa-clara 
|
|
#2
04-17-2017, 10:34 AM
|
|||
|
|||
|
16-45ft lbs is all you need. Over torquing potentially shifts your barrel changing your POA. Is the barrel extension shoulder (rear facing side) square/flush? And is the front of your upper square/flush? Have you tried torquing it slightly a few times, backing off, getting a slight stretch, then going for gold? I've torqued hundreds of barrels and only had 2 teeth break separate times.
|
|
| Thread Tools | |
| Display Modes | |
|
|
 |
 |
 |
Linear Mode
