|
Deals, Sales and Coupons Found a good deal or sale? Got a coupon or code? Share them here! |
|
Thread Tools | Display Modes |
#84
|
||||
|
||||
looking for one if anyone has an extra. again I missed it
__________________
Quote:
|
#87
|
||||
|
||||
Mine are good to go thus far.
All drill points have centering towers on both sides.
__________________
|
#92
|
||||
|
||||
My 3 arrived today. all look very good.
|
#100
|
||||
|
||||
Quote:
My order went through I kept trying over and over again. |
#112
|
||||
|
||||
Will someone figure out the tax for one at 35. Coming up with 9.6+%? What city has that tax?
My tax charge is $3.38 Before the shipping went back down I want to say my tax charge was $4.3? Hmm Last edited by Sub95; 10-10-2013 at 7:27 PM.. |
#114
|
||||
|
||||
They're piece of junk. Personally, I rather pay extra $50 and go with the aluminum one & be done with it instead of spending extra time and money fixing these so called "blemished" lower.
Last edited by RookieShooter; 10-14-2013 at 4:33 AM.. |
#115
|
||||
|
||||
As for buying one of these again, NO, I won't. Just on there shipping change and blaming it on a glitch, and won't reply to questions.
And as for the lowers there hit and miss, I got 8 of them, 2 non blem green and pink and 6 black blems. Pink finish was not great but I didn't have to fix anything on it. Od green, was a mess and needed a lot of epoxy to fix, front lower wall was to thin even before you take the moulding bumps out. Safety hole was way off and had to be filled with epoxy and re drilled, hammer/trigger marks were to low. Black blems finish was a lot better on them then the colored ones. But none needed epoxy but a few needed hammer/trigger holes moved up or squared up to one another. I think the only reason for this is because I caught all the problems on my first one I did and double checked all markings before I drilled them out. I used a drill press with x y table after I did the first one with a dremel. |
#116
|
||||
|
||||
I tried to put an OD Green EPArmory.com blem into a jig last night, the takedown pin holes were a tiny bit off making it impossible to get the EPArmory 80% into the jig.
__________________
|
#120
|
||||
|
||||
I don't think that is an issue. Both of mine look just like that, but all of my uppers fit the EP lowers just fine.
__________________
War is when your Government tells you who the enemy is...... Revolution is when you figure it out for yourself. |
Thread Tools | |
Display Modes | |
|
|