Quote:
Originally Posted by 80% Arms
Sorry for the confusion, posted after a long day at 12:30 AM and evidently did not drink enough coffee before doing so 1.5 in flue length is ok, manual is written around that. Shorter flute lengths are optimal but difficult to find. 1.25 inches is perfectly usable. We're making some custom end mills made that will have a shorter flute length and be a bit cheaper than McMaster, but don't have an ETA on that yet. Apologize for the typo in the quoted post.
|
Got it. Thanks.
I found some end mills that have 1" flutes.
http://www.mscdirect.com/webapp/wcs/...oduct/76488634
They're currently in stock, and there's even a coupon code for free shipping: BSRFREE
These are pricier than the McMaster part but if the shorter flute length helps prevent damage to the jig and lower it will be a bargain, especially considering the backorder time now.
__________________
JPFO Genocide Chart Note that seven of the nine genocides documented in the
Genocide Chart were perpetrated against "political opponents." If you're a Christian, a gun owner, and support the Constitution and natural rights, then
you are a political opponent to the Marxists who control the CA and US regimes, and to their armies of useful idiots.