Quote:
Originally Posted by 80% Arms
You'll need to be really, really careful with that end mill. It has a 1.25 inch flute length, which is going to greatly increase chances of chewing up the jig. If you can get anything with 1 inch or less flute length it would be much better.
|
Now I'm very confused. The "EASY JIG INFORMATION" page recommends the McMaster end mill with 1.5 inch flutes and says, "Max flute length is 1.5 inches, shorter flutes ok."
So what it looks like to me is that 80% Arms is recommending a 1.5 inch flute (McMaster part number 88815A44), cautioning against a 1.25 inch flute length, and recommending 1 inch or less flute length. Does that mean 80% Arms is cautioning even more against the McMaster part than the 1.25 inch flute part? If so, why recommend it? What am I missing?
__________________
JPFO Genocide Chart Note that seven of the nine genocides documented in the
Genocide Chart were perpetrated against "political opponents." If you're a Christian, a gun owner, and support the Constitution and natural rights, then
you are a political opponent to the Marxists who control the CA and US regimes, and to their armies of useful idiots.