View Single Post
  #3  
Old 01-03-2012, 1:11 AM
darkest2000's Avatar
darkest2000 darkest2000 is offline
Senior Member
 
Join Date: Oct 2006
Location: Orange County, CA
Posts: 1,340
iTrader: 158 / 100%
Default

forgot to mention, you'll need to install a rear lower tang for the correct military type stock to fit. your receiver should already be milled to accept one, it's just not installed at the factory because of the thumbhole stock.

http://www.cncwarrior.com/shop/23481...ak-lower-tang/
http://www.k-var.com/shop/home.php?cat=308

The lower tang is held in place by 2 rivets. You need to drill out the existing rivets first. Pressing the rivets is really easy to do if you have AK builder's rivet jig and a hydraulic press. If not you can get by with some nuts and bolts until you're ready to put some real rivets in place.

__________________
Regards,
Mike

Last edited by darkest2000; 01-03-2012 at 1:24 AM..
Reply With Quote