View Single Post
Old 12-25-2012, 11:49 AM
CGT80 CGT80 is offline
Veteran Member
Join Date: Jul 2008
Location: Fontana, CA USA
Posts: 2,919
iTrader: 14 / 100%

I am disappointed that I have to debur, but I am thrilled with the ease and speed over using my other trimmer. I don't see how a drill press would help consistency. Most of my brass is + or - 2 thousandths, so maybe something is off with your cutter. I did see that the angle inside the guide may not be exactly the same as my brass. I wonder if the plastic will wear a couple thousandths until it matches the brass better. My brass had a slight ring on the neck that wasn't even. I haven't checked that ring lately, but I have run a bunch of brass through it.

I may try to post up a video of my trimmer, later.
He who dies with the most tools/toys wins
Reply With Quote