View Single Post
Old 05-04-2017, 12:39 PM
UclaPeon44 UclaPeon44 is online now
Junior Member
Join Date: Dec 2016
Posts: 79
iTrader: 8 / 100%

Test install your slide without recoil spring and barrel. It should slide back and forward with little to no binding. If you used hand drill for your pins. It's more than likely both front and rear rails are slightly canted and you need to file/sand your rails to free up binding issues.

Originally Posted by papafloyd View Post
"When you installed the locking block, were the holes misaligned?"

No they are straight. The locking block is not where it is's the Rear Rail module. Getting better but may just need a little polishing.
Reply With Quote