View Single Post
  #129  
Old 04-12-2009, 6:29 PM
nicoroshi's Avatar
nicoroshi nicoroshi is offline
www.Buildyourownak.info
CGN Contributor - Lifetime
 
Join Date: Jan 2009
Location: Da East Bay Bro!
Posts: 3,697
iTrader: 23 / 100%
Default

I did a version of this with my 30 round PMAG rebuild kits but took some of the better ideas I saw elsewhere, and incorporated them.

Here's what I did:

Four 30 round PMAG rebuild kits:


Hanger (which fits perfectly into the spring support on the bottom of the follower) to sacrifice in the name of CA legality:


Load 10 rounds on a follower without a spring, and measure distance from inside of spring support to base of mag (M-16 brush fits perfectly also, and marked it with a razor knife slice into the brush side):


Measure the distance:


Cut the hanger, and drill hole through follower with hanger piece installed:


Secure with pan head screw (to keep it from rubbing on the inside of the mag):


(cont................)
Reply With Quote