View Single Post
Old 08-09-2013, 2:48 PM
calcul8's Avatar
calcul8 calcul8 is offline
Junior Member
Join Date: Aug 2009
Posts: 28
iTrader: 1 / 100%

Originally Posted by BlaZed View Post
I am in the process of converting my pmag and came up with a different solution. Instead of putting a rod in the follower, why can't you put a rod in the bottom spring holder? I see two advantages to this:

1. Your rod is not constantly moving with the follower, it will be stuck on the base (Should help with durability).

2. When you leave CA, couldn't you remove the base plate, remove the bottom spring holder (with rod), and reassemble with the spring resting on the base plate?

Would this solution be acceptable or do I have to epoxy the base onto the mag?

Here is a pic showing a wooden dowel in the follower, and one in the bottom spring holder:
From what I was told and in my reading of the law, I believe the modification has to be permanent and non-reversible.
Reply With Quote