View Single Post
  #2  
Old 06-13-2009, 9:12 AM
fredieusa's Avatar
fredieusa fredieusa is offline
Member
 
Join Date: Mar 2008
Location: Contra Costa County
Posts: 439
iTrader: 84 / 100%
Default

Receiver and Trunions

Crimping/crushing rivits is the same as in the demilled kit so I will run over this fast.

Here the trunion holes were slightly small (for AKbuilder rivits) so I ran a drill through them.


Now install the trunions in the bent receiver and line holes up. For a Yugo M70AB2 you will have to drill an additional hole in the bulge of the trunion. Most receivers have the hole drilled so just center punch and drill away.

Here the receiver is almost complete with all rivits and trunions, including the Mag release/trigger guard and the pistol grip nut.
This came out pretty squared-up and decent.




Last edited by fredieusa; 07-03-2009 at 6:30 PM..
Reply With Quote