View Single Post
  #36  
Old 08-02-2013, 2:20 PM
jonnietyler jonnietyler is offline
Junior Member
 
Join Date: May 2011
Posts: 29
iTrader: 0 / 0%
Default

I bought a Tavor bullet button at North County Firearms. I was able to get it installed on my Tavor, however, one of the holes on the shroud is drilled too small for the set screw.

It seems to work fine with only using 2 of the large set screws and the one small set screw.

What size drill bit should I use to get the 3rd set screw to fit?
Reply With Quote