View Single Post
  #2  
Old 02-26-2014, 11:05 AM
tiller tiller is offline
Senior Member
 
Join Date: Jun 2011
Posts: 794
iTrader: 5 / 100%
Default

Quote:
Originally Posted by Carpasteis View Post
Anyone ever have this issue?

Using a dillon 1050 and roughly one primer out of 25 doesn't get seated properly and falls out of the bottom of the machine. If I'm on a roll I don't notice it and it gets filled with powder causing a mess of powder as it goes around the plate. Now i'm paranoid and checking almost every case under the powder dispenser. Is this a swage issue? Brass issue?
Tear it down and completly clean the primer feed! Every hole you can find clean it!

Also change out the little blue tab that holds the primers in the tube... Its plastic, it wear out easily
__________________
.223 & .308 brass processing
Reply With Quote