View Single Post
  #4  
Old 07-25-2014, 1:42 PM
VaderSpade's Avatar
VaderSpade VaderSpade is offline
Vendor/Retailer
CGN Contributor
 
Join Date: Mar 2009
Location: In the hills above Redding, CA
Posts: 3,985
iTrader: 61 / 100%
Default

Looking good, On to the drilling.

Not much to be said about drilling. One thing that has come up is drill flex. Whenever I’m drilling with a bushing I don’t put the jig tight in the vise. Leave yourself a ¼ inch or so. If the bit catches, the vise will stop it from spinning, otherwise the jig will self-center as you bring the bit down.





A mouse with 220 grit quickly takes off any mill marks. I'll clean that up a little more before the Cerakote.





The measurements are all nearly perfect but there's still a lot of fitting to do. That will need to wait till I'm in my easy chair watching a chick flick with the wife. Two birds with one stone.

__________________

Check out my engraving gallery on my website, Thanks
http://vadertactical.com/engraving-gallery

Last edited by VaderSpade; 07-26-2014 at 10:22 AM..
Reply With Quote