Quote:
Originally Posted by aqua_scummm
So I think I recall reading in a previous thread that these will be replacing some roll pins with threaded pins/rods... Is that correct?
Is there anything I need to know when ordering parts, in regards to this? I know we have plenty of time, but I'm starting to gather orders/part numbers, and if I need to buy a few specific pins I'd like to get them and set them aside now...
Thanks!
Matt
|
Perhaps Addax will chime in with any specifics.
I don't think there's been any discussion about roll pins/rods/etc with relation to these lowers. Perhaps you are recalling a thread where people were discussion modifications they do when building?
These are standard mil-spec stripped lowers. Any lower parts kit should fit them.
__________________
WTB: multiautomatic ghost gun with a .30-caliber clip to disperse with 30 bullets within half a second. Must include shoulder thing that goes up.
Memberships/Affiliations: CERT, ARRL ARES, NRA Patron Member, HRC, CGN/CGSSA, Cal-FFL