View Single Post
Old 10-17-2012, 9:56 PM
fourtraxmc fourtraxmc is offline
Join Date: Apr 2012
Posts: 395
iTrader: 23 / 100%

Originally Posted by wash View Post
I suggest finding a place to do your machining that is not owned by an FFL holder.

FFL holders are heavily scrutinized by the CA DOJ. After the OLL drama at RMB back in the day, I see no reason to allow them access anywhere they don't need to be.

I spoke to the shop owner today and he would like to do them but his plate is full right now. We have discussed the ffl issue also, it is his call on that . I have access to a manual mill, TM jig and most of the tooling. That might be the route that it goes.
Reply With Quote