View Single Post
  #5  
Old 07-11-2018, 1:55 PM
M1NM's Avatar
M1NM M1NM is offline
Calguns Addict
 
Join Date: Oct 2011
Location: West Covina
Posts: 5,894
iTrader: 48 / 100%
Default

Get the RCBS swagger cheap and works fine. You don't need gauges. Use the RCBS dies and set them per instruction sheet and you won't need small base dies. I'd get a good - cast iron - single stage press. Not sure how pot metal Lees hold up the full length resizing of bottleneck brass. Flare & Crimp not necessary. Trimming is not required every time - and rarely before the 3-5 loading.
Get a Forester trimmer they do trim to a specific height from base to top not based on the shoulder.
__________________

Last edited by M1NM; 07-11-2018 at 1:59 PM..
Reply With Quote