View Single Post
Old 12-15-2012, 12:32 AM
allstarauto's Avatar
allstarauto allstarauto is offline
Join Date: Aug 2011
Location: Alta Loma
Posts: 214
iTrader: 17 / 100%

just drilled a whole in the triple tap, kinda hard inconel has a lot of nickel in it. I used 2 1/16 tiNic drill bits from homedepot. then spaced with the washers that come with the brake and then followed the drill through the existing hole that I made, careful not to go through the barrel. I cut off a piece of the drill and tapped it through the hole and then welded it! cleaned it up and painted it with teflon moly paint to give it that clean look.
current guns, Barrett M82A1, Remington 700 AICS, JD Machine AR-10, JD Machine AR-15(2), Ar-15 Noveske Infedel(2), TNT AR-15(2), shtf AR's(2),AR pistol,SCAR16, SCAR17, FNH FS2000, GSG-5, FNP45 Tactical,FN57, FNP9, Desert Eargle 50AE, Glock 36/22/17, XD9, Kimber Desert Warrior, Kimber Raptor II stainless, CZ P07, CZP01 Shadow Target,KSG, Springfield TRP full rail and a whole mess of other guns...
Reply With Quote