Originally Posted by rimfire78
I started trying to remove the front chopped gas block so that I can install a YHM flip sight, but I can't get the taper pins to budge even after soaking them in WD-40.
AT this point, I'm beginning to make a mess of things. The next step would be drilling them out
Drilling them never ends well.
I have a pressing fixture for removing and installing taper pins.
AR work: www.ar15barrels.com
Bolt actions: www.700barrels.com
Foreign Semi Autos: www.akbarrels.com
Glock, XD and M&P pistols, Benelli and Remington shotguns: barrel, sight, trigger and receiver work.
Most work performed while-you-wait, evening and weekend appointments available.
Founding member of the CAPRC