View Single Post
  #13  
Old 11-19-2012, 10:50 PM
mattmaxsr's Avatar
mattmaxsr mattmaxsr is offline
Junior Member
 
Join Date: Dec 2010
Posts: 15
iTrader: 0 / 0%
Default

Well I figured I post a progress report!
After cleaning up my shop, I decided it was time to finish my build
I did use the undersized drill and reamed the barrel hole to about .001" under the measured size of my Green Mountain Bull barrel then heated the receiver to about 180 to 200 deg.
The barrel slipped right in and I had time to line up the V-block and snug up the V-block as it cooled. it ended up working really well. as for drilling the Barrell hole I didn't use the jig!
I used the milling dimple left on the receiver as the mark to center punch a point for the drill to follow, then reamed it to size.
As others have said my Hogue stock was to tight, had to dremel to size in front of the magazine.
1st pict. My new baby

2nd pict. first trip to the range 25yrds

3rd is the chamber?!?!
Attached Images
File Type: jpg Custom (TPC 10 22 SemiAuto 22LR).jpg (85.5 KB, 33 views)
File Type: jpg first shots out of my build.jpg (84.0 KB, 32 views)
File Type: jpg OPEN BOLT RECEIVER.jpg (98.7 KB, 29 views)
__________________
Matt
""Keep Smiling...It'll keep em guessing""
www.TPCBots.com
Reply With Quote