Thread: FAL assembly?
View Single Post
  #40  
Old 11-16-2012, 6:28 AM
-hanko's Avatar
-hanko -hanko is online now
Calguns Addict
 
Join Date: Jul 2002
Location: Bay Area & SW Idaho
Posts: 9,492
iTrader: 6 / 100%
Default

Quote:
Originally Posted by Cessnapilot89 View Post
Should any type of anti seize be used on the thread?
I use StaLube assembly grease, p/n SL3333...NAPA auto parts or similar...outstanding for AR triggers, bolt rifle bolt lugs, etc. Lotsa' guys just use light oil. Use a very light coating of whatever you pick, and make sure you can hand-tighten until the barrel shoulder contacts the receiver.

Double check that the rear of the barrel is NOT making contact with the receiver. If it does, you'll need to relieve the receiver (gently) until there's no interference.

I use a breaker bar on the wrench and a chunk of pipe about 3 feet long if necessary, and it usually is. I've had better luck bolting the barrel vise to a bench than sticking it in a vise.

Pics of the finished gun will be required.

hth

-hanko
__________________
"Tactical" is like boobs...you can sell anything with it....arf


Originally Posted By System Message:
Why can't you guys participate in a simple discussion about some guy's mom making a porno without violating the COC? This is why we can't have nice things.



“Heaven goes by favor. If it went by merit, you would stay out and your dog would go in.”
Mark Twain
Reply With Quote