View Single Post
  #54  
Old 11-04-2012, 11:15 PM
markw markw is offline
Senior Member
 
Join Date: Jun 2007
Location: San Diego East County
Posts: 806
iTrader: 9 / 100%
Default

Quote:
Originally Posted by elsolo View Post
The firing pin blocker lever is the primary cause of the long trigger reset.

You can remove the blocker pin and spring from the slide and grind the lower leg off the lever that actuates it, that's the easiest way.

If you want or need to retain the FPB, you need to make it work with less travel so the triggerbar clears it at the same time it clears the sear lever's lower leg.
The spacer is 2.5mm wide with a 3mm hole and about 5mm in diameter. The ones supplied by CGW are nylon. Shouldn't be too hard to find at a hobby shop or a real hardware store.
Reply With Quote