View Single Post
Old 05-19-2012, 12:26 PM
savs2k savs2k is offline
Senior Member
Join Date: Jan 2007
Posts: 1,817
iTrader: 16 / 100%

Jeepers, as a machinist when you see someone using a dremel to cut multiple rails to spec ours nothing more then amazing. Even my first few times on a manual mill,I admit I couldn't make any parts within the proper tolerances. I can't imagine someone using a dremel and that be one of the main ways suggested to people who have low to zero machining experience. I guess my answer to your question is any idiot could make a line into steel with a dremel. But there are only a few who can do it into the correct tolerances and not create binding
Reply With Quote