View Single Post
Old 02-26-2012, 6:40 AM
SR-71 BLACKBIRD's Avatar
Senior Member
Join Date: Feb 2011
Location: Douglassville, PA
Posts: 678
iTrader: 4 / 100%

From nose to tail

Step Fathers (the AR-10 with traditional upper and smaller scope):

JP Bennie Cooley Muzzle Brake
Ace hardware hardened steel washer (pain in the rear to fit)
DPMS 18" SASS mid length fluted stainless steel black teflon barrel
DPMS low profile gas block .936 (plus roll pin sold separately)
DPMS mid length gas tube
Fulton Armory Phantom rifle length hand guard DPMS pattern
Hand guard rail 2"
LaRue Tactical Harris Bipod BR-S with their LT130 QD mount
DPMS upper (came with dust cover and forward assist)
DPMS chrome BCG
Vltor BCM Gunfighter medium size charge handle
DPMS lower, came with bullet button & 10 round mag (non panther CA legal)
CMC drop in trigger with flat trigger 3.5# pull
Command Arms Interchangeable Pistol Grip
Magpul PRS ar308
DPMS Butt stock Assembly (Have a traditional stock if I want to switch it out)
Magpul 10/20 mags
Magpul PRS Extended recoil pad .5"
American Defense Recon quick release 20 MOA 30mm one piece scope mount
Millett Tactical TRS-1 30mm 4-16x50 side focus illuminated Mil-Dot


Everything above except for
Fulton Armory Titan side cocking flat top upper
Complete BCG Titan with side cocking handle installed
American Defense Recon quick release 20 MOA with 35mm rings
Millett Tactical LRS 35mm 6-25x56mm side focus illuminated Mil-Dot

.308 upper receiver block (claw)
PRI upper receiver take down pin vise block
Forster Head space .308 GO and NO Go tools
I already had the punches, non marring brass hammer, levels, feeler gauges, hand guard install tool, torque wrench, vise, ect ect....

I was as happy as a grade school-er on Christmas morning after finally finishing these two. I'm flying out to New Mexico (where step dad lives) in a few weeks, and I'm bringing these twins out with me. I plan on hand delivering his to him. He has a house down at Elephant Butte with a 600 yard range near by. He has a Caldwell lead sled shooting rest, and we will sight these bad boys in together.

I also made sure to get lowers with sequential serial numbers

I hope this build list helps a future AR-10 project. This AR-10 tread certainly helped me.

Last edited by SR-71 BLACKBIRD; 02-26-2012 at 7:09 AM..
Reply With Quote