View Single Post
  #1  
Old 12-13-2011, 10:26 AM
ontargetrange's Avatar
ontargetrange ontargetrange is offline
Vendor/Retailer
CGN Contributor - Lifetime
 
Join Date: Dec 2008
Location: Laguna Niguel, Ca
Posts: 298
iTrader: 0 / 0%
Exclamation Steel Jacketed Ammo

All,

Over the past year I noticed a decided change in ammo being shot here in the range. It concerns me that just maybe some shooters out there may not know what they are shooting is damaging their firearms.

As we clean out the spent rounds from our rubber backstop we always examine what has been shot and what amount of this or that caliber was used. Not in detail, but just to see what happens to bullets. We see every kind of projectile imaginable in all the calibers up to .50BMG – we don’t allow that here.

Just by chance we swept a large magnet across the pile of bullets (see attached PDF labeled – bullets to see what +15,000 pounds looks like), and found some bullets that were magnetic. While we have seen some bullets in the past with a steel core or steel jacket, the amount we found concerned me. See attached PDF labeled Steel Ammo.

I did a complete search through all of our ammo and found that the only steel encased bullets were the Wolf and Tula brands. Nothing else we sell had a steel jacket, including our reloads. We started watching what was being shot and we did not find the supplier of the steel jacketed rounds. We did ask some of our known reloaders if they were using steel or bimetal jacketed rounds, but they all assured us they were not.

We just did a de-leading operation here and found a considerable increase in steel jacketed rounds being fired. So much so that I felt inclined to write this up and post in where I could. I know that this ammo has to be “cheaper” to purchase and is the primary reason for the increase in use.

I don’t think that shooters fully understand the damage being done to their firearm when they shoot copper flash coated, steel jacketed, lead filled rounds. No matter what, the steel will come into contact with the steel of your barrel. The very light copper flash coating of the bullet quickly burns off as it moves down the barrel. I would guess that by the time the bullet moves more than two inches the copper is gone on the sharp edges of the rifling and then you have steel to steel contact. I have looked at some of these bullets taken from the pile randomly and without exception they all have zero copper left where the edge of the rifling meets the jacket.

I cannot, nor will I, mandate someone use a specific kind of ammo in THEIR firearm. I can with our range guns and with my personal firearms. Having a background in manufacturing I know firsthand what happens when you rub steel against steel at high speed and add heat to the process. Eventually the barrel will become smooth and all sense of rifling will be gone. Then what do you have?

I know what a new barrel costs and the problems with replacing them. Shooting this steel material through your firearms is a disaster waiting to happen. Don’t think for a minute that it will hurt just to do a box or two. Even once is too many times.

Please note I am talking about PISTOL ammo in 45acp and 9mm as well as some .223. All of these are NOT bimetal jackets, but steel with a flash coating of copper.
Attached Files
File Type: pdf Bullets.pdf (140.1 KB, 355 views)
File Type: pdf Steel Ammo.pdf (597.8 KB, 323 views)
__________________
Regards

Gregg



NRA Supporter & Life Member
CRPA Life Member

Last edited by ontargetrange; 12-14-2011 at 1:23 PM..