View Single Post
Old 10-19-2011, 12:18 PM
ke6guj's Avatar
ke6guj ke6guj is offline
CGN Contributor
Join Date: Nov 2003
Location: 909
Posts: 23,786
iTrader: 42 / 100%

Originally Posted by seainc View Post
Few questions:
1. It seems MP5K pistol clone will not be allow because its barrel is under 7.5", correct?
not sure where you came up with that 7.5" number. SSE requires a 6" barrel, but I dont' think a 5K has even that, so you'd have to have a barrel extention permanently attached along with the zero-round mag (SLED)

2. For the MP5 clone pistol, if seller send in with mag disassembled and no BB installed, will it meet the legal SSE-P requirements? if not, how to make it into SSE-P?
An MP5 with a standard magazine release would be an AW, a felony. It needs to have a maglock installed before it comes into CA. In addition, it would need a SLED installed to be SSE.

3. How to make HK45 into SSE-P for transfer?

have barrel extended to at least 6" (probably need to be closer to 7-8" to make 10.5" OAL) and have a SLED installed with a mag lock.

12133(b) The provisions of this chapter shall not apply to a single-shot pistol with a barrel length of not less than six inches and that has an overall length of at least 10 1/2 inches when the handle, frame or receiver, and barrel are assembled.

Do you want an AOW or C&R SBS/SBR in CA?

No posts of mine are to be construed as legal advice, which can only be given by a lawyer.
Reply With Quote