View Single Post
  #3  
Old 07-15-2011, 11:11 AM
LoneWolfDistributors's Avatar
LoneWolfDistributors LoneWolfDistributors is offline
Vendor/Retailer
 
Join Date: Jun 2011
Posts: 35
iTrader: 0 / 0%
Default

Here's an update.....


This is a PROTOTYPE mag release system we are working on to get these into CA...

I must stress this a prototype. We started by cutting the mag release paddle off but you could still squeeze your finger in there and get the mag to release so we had to come up with a new plan. We made a plug that goes over and doesn't allow your finger to get there.

In production runs we'd likely make the block out of polymer. We have to reach out to our DOJ contacts to see if they are going to have a problem with the block being screwed into the receiver or if we are going to have to glue it in.

The small hole in the mag release is sized for a standard glock take down tool or punch. It forces you to use a tool to get the mag out.

Let me know what you guys think.
Attached Images
File Type: jpg protoARrelease.jpg (87.5 KB, 389 views)
__________________
Marketing Staff
Lone Wolf Distributors
Reply With Quote